American Power Conversion n 132 Fairgrounds Road West Kingston. See the manual section entitled Installation for instructions on how to lock mated couplers.

Matrix™ UPS Models 3000 and 5000. Manual, may cause harmful. American Power Conversion (APC) does not recommend the use of any of. RefurbUPS is your Trusted Source for New UPS solutions from Leading Manufacturers. RefurbUPS knowledge on the APC Symmetra PX UPS. Matrix 3000 XR User's Manual.

Issue Where can I find the answers to commonly asked questions about the Matrix UPS? Product Line Matrix UPS Environment All serial ranges Cause Some common questions may arise during the installation or use of a Matrix UPS.

Resolution This document provides the answers to commonly asked questions regarding installation of the APC Matrix UPS. Installation Hints 1.

Matrix-UPS should be set up on a solid level surface if possible. Padding on floor will help dampen system noise. User needs to know input voltage to Matrix-UPS. If 240VAC input, Matrix-UPS Input Select Tap Wire must be moved. Set Matrix-UPS EU (Electronics Unit, the top half of the unit) in place on top of Matrix-UPS IU (Isolation Unit, the bottom half of the unit) and tighten rear knob. Add SmartCell battery packs to system, either on top of Matrix-UPS or by its side.

Hook Anderson connector from SmartCell battery pack to EU slot, then add SmartCell communications cable. Note: Battery communication cable must go from EU's 'batt com' input to the 'output' marking of first SmartCell.

Follow this pattern for additional SmartCell battery packs. Keygen Jcreator Pro 4.50. Once all pieces are connected, turn main circuit breaker located on the rear of Matrix-UPS IU to 'ON' position. Front LCD display should read On-line with a% load. Vanbasco Karaoke Gratis Italiano Per Windows Xp here. If LCD display does not illuminate, press all three buttons found directly underneath the display simultaneously. User can then scroll through menu option of the LCD display to check current Matrix-UPS settings. Change the sensitivity setting to LOW (default is AUTO). This LOW setting is preferred.